3M ESPE Elipar DeepCure-L Instrucciones De Uso página 6

memory effect and can therefore be recharged at
any time by inserting the charger plug into the
charging socket of the handpiece (see the section
"Battery Power Level Display on Handpiece").
Before using the handpiece for the first time, connect
it to the charger for a period of about 2 hours so that
the new battery is completely charged for the first
time.
The green status light on the handpiece blinks while
the battery is charging. The green status light glows
steadily when the device is fully charged. As a safety
precaution, light-curing is not possible while the
device is charging.
Battery Power Level Display on Handpiece
Status LED
Handpiece without Charger connected
charger
Steady green light Handpiece ready
for operation
Flashes green ––
Steady red light Low battery charge Problem during
Flashes red Battery fully
discharged,
exposure cycle will defective or cannot
be completed or,
if in continuous
mode, stopped
Status LED
Operating status
Charging has been
completed
Battery is being
charged
charging
Problem in
charging, battery is
be charged
Operation
Selection of Exposure Time
{
LED showing
exposure times
Exposure time options: 5, 10, 15, 20 sec, continuous
mode (120 sec), tack-cure mode (1 sec).
See the instructions for use for the specific dental
material when selecting the exposure time.
The indicated exposure times assume that the light
guide is held at the exact position over the material
being polymerized.
If the distance between the light guide and the
restoration is increased, the exposure time must be
adjusted accordingly because the light intensity
weakens (see graph).
100
90
80
70
60
50
0 1 2 3
Distance (mm)
Select the exposure time by pressing the TIME button.
- The selected exposure time is indicated by the
4 green LEDs.
- Each time the button is briefly pressed, the setting
advances to the next (higher) value. All 4 green
LEDs will be turned on for a setting of 20 sec.
Pressing the button again will turn off all of the
LEDs and enable the continuous mode.
- The display advances through the available
settings if the button is kept depressed.
START button
TIME button
4 5 6 7 8 9 10
5