Tabla De Contenido; Introduction - Husqvarna 445 II Manual De Usuario

Introduction................................................................... 19
Safety............................................................................20
Assembly...................................................................... 23
Operation...................................................................... 24
Maintenance................................................................. 30
Product description
The Husqvarna 445 II, 445e II, 450 II, 450e II are
chainsaw models with a combustion engine.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Product overview
(Fig. 1)
1. Cylinder cover
2. Air purge bulb
3. Start decal
4. Start/stop switch
5. Rear handle
6. Information and warning decal
7. Fuel tank
8. Adjuster screws carburetor
9. Starter rope handle
10. Starter housing
11. Chain oil tank
12. Product and serial number plate
13. Felling direction mark
14. Front handle
15. Chain brake and front hand guard
16. Muffler
17. Saw chain
18. Bar tip sprocket
19. Guide bar
20. Spiked bumper
21. Chain catcher
22. Chain tensioning screw
23. Clutch cover
24. Right hand guard
25. Throttle trigger
26. Throttle trigger lockout
27. Operator's manual
28. Combination wrench
29. Guide bar cover
1286 - 002 - 03.06.2020
Contents
Troubleshooting............................................................ 36
Transportation and storage...........................................37
Technical data.............................................................. 37
Accessories.................................................................. 39
EC Declaration of Conformity....................................... 41

Introduction

Intended use
This product is intended for sawing in wood.
Note: National regulations can set limit to the operation
of the product.
Symbols on the product
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig. 11)
(Fig. 12)
(Fig. 13)
(Fig. 14)
Stop.
WARNING! Be careful and use the product
correctly. This product can cause serious
injury or death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
This product complies with applicable EC
Directives.
Noise emissions to the environment
according to European Directive 2000/14/EC
and New South Wales legislation "Protection
of the Environment Operations (Noise
Control) Regulation 2017". Noise emission
data can be found on the machine label and
in the Technical data chapter.
Choke.
Idle adjustment screw.
High speed needle.
Low speed needle.
Fuel.
Chain oil.
Air purge bulb.
19