Features; Unpacking And Assembly - Urrea CC707 Manual De Usuario

· Give your work undivided attention. Look-
ing around, carrying on a conversation, and
"horse-play" are careless acts that can result in
serious injury.
· Ensure that the directional arrow marked on
the blade corresponds with the rotational di-
rection of the motor.
· With the machine disconnected from the
power supply, rotate the blade by hand to en-
sure it is free from obstruction.
· Always keep the blade securing arbor and
collars clean.
· Ensure that the blade-securing bolt is secure-
ly tightened with a suitable wrench.
· Never try to cut freehand. Always ensure that
the tile to be cut is pressed firmly against the
parallel side fence.
· Ensure that the work piece to be cut off has
sufficient room to move sideways. Failure to do
so may result in the off cut binding against the
blade.
IMPORTANT: Never cut more than one tile
at a time.
· Never cut pieces too small to be held securely
against the side fence without leaving enough
space for the hand to be a safe distance from
the blade.
· Ensure that the table and surrounding area
are clear with the exception of the tile to be
cut.
· Never fit substandard blades to the machine.
Only fit correctly sized diamond blades.
· Before cutting a tile piece let the saw blade
run freely for a few seconds. If it makes an
unfamiliar sound or vibrate excessively switch
it off immediately and disconnect from the
power supply. Investigate the cause or consult
a qualified person for advice.
· Let the blade reach full speed before com-
mencing the cut.
· Do not force the blade to cut the tile.
· Let the blade come to a complete stop before
removing any jammed or off cut material from
around the blade area.

FEATURES

KNOW YOUR TOOL
Before attempting to use this tile cutter, be-
come familiar with all of its operating features
and safety requirements.
E N G L I S H •
WARNING: Do not allow familiarity with
the tile cutter to cause carelessness.
Remember that a fraction of a second of care-
lessness is enough to inflict severe injury.
1. PROTECTIVE GUARD.
2. EXTENSION TABLE.
3. MITRE CUTTING GUIDE.
4. ON/OFF SWITCH.
5. POWER CORD.
6. WORKING TABLE.
7. 45° VERTICAL FENCE.
8. WATER RESERVOIR PLUG.
6
2
5

UNPACKING AND ASSEMBLY

The tool is packed complete in one carton.
When unpacking and checking the contents
of the carton, separate all the parts from the
packing material and check each one against
the pack contents shown below to make sure
that all items are accounted for.
If any parts are missing, do not attempt to as-
semble, or use the tile cutter until the missing
parts are obtained and installed correctly. Any
missing parts should be reported immediately
to the store from which you purchased the
tool.
INSTALLATION OF THE METAL BRACKET
Unplug the tile cutter from the mains supply.
Remove the cover (45° vertical fence) of the
water reservoir.
U se r's m a nua l
8
1
7
3
4
11