Changing The Engine Oil - Toro 20377 Manual Del Usuario

Figure 27
1. Latch tabs
3. Open the cover.
4. Replace the air-filter element.
5. Install the cover.

Changing the Engine Oil

Service Interval: Every 50 hours/Yearly (whichever comes
first)
Changing the engine oil is not required, but if you desire
to change the oil, use the following procedure.
Note: Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Engine oil capacity: 0.5 L (18 oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
g027312
g027312
2. Air-filter element
14).
(Figure 28).
4. Tip the machine onto its side (so that the air filter is up)
to drain the used oil from the oil-fill tube
5. After draining the used oil, return the machine to the
operating position.
6. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
10. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low, carefully
pour a small amount of oil into the oil-fill tube,
wait 3 minutes, and repeat steps
oil level on the dipstick is at the correct level.
•
If the oil level on the dipstick is too high, drain the
excess oil until the oil level on the dipstick is at the
correct level.
15
Figure 28
(Figure
Figure 29
(Figure 28).
8 through until the
g188681
29).
g188765