Connection With The Mains; Operation; Stand Alone Operation; Dmx-Controlled Operation - Futurelight DJ-HEAD 575 WASH Manual Del Usuario

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the DJ-HEAD 575 WASH starts running. During the Reset, the
motors are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the DJ-HEAD 575 WASH can be used without controller.
Disconnect the DJ-HEAD 575 WASH from the controller and call the internal program.
Please refer to the instructions under Control Board.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the DJ-HEAD 575 WASH will respond to the controller.
If you set, for example, the address to channel 17, the DJ-HEAD 575 WASH will use the channel 17 to 32 for
control.
Please, be sure that you don't have any overlapping channels in order to control each DJ-HEAD 575 WASH
correctly and independently from any other fixture on the DMX-chain.
If several DJ-HEAD 575 WASH are addressed similarly, they will work synchronically.
For address setting follow this procedure:
1. Switch on the DJ-HEAD 575 WASH and wait until the fixture reset has finished ("rSt" is flashing at the
display).
2. Press the [Mode] key in order to access the main menu. Browse through the menu by pressing the [Up]
and [Down] keys until the display shows "A001". Confirm by pressing [Enter] key and the letter "A" will
flash.
3. Use the [Up] and [Down] keys to select the desired address.
4. Confirm by pressing [Enter] or [Mode] to cancel.
International
L
N
36/91 51839565_V_1_0.DOC