Setting The Spotlight Into Operation; Installation; Barn Doors; Power Supply - IMG STAGELINE ODC-100/ RGB Manual De Instrucciones

light is used for other purposes than originally
intended, if it is not safely installed or not cor-
rectly connected or operated, or if it is not re-
paired in an expert way.
If the spotlight is to be put out of oper-
ation definitively, take it to a local recy-
cling plant for a disposal which is not
harmful to the environment.
3 Setting the Spotlight
into Operation

3.1 Installation

G
Always position the spotlight in such a way to
ensure sufficient air circulation during opera-
tion. Never cover the cooling fins of the hous-
ing.
G
Always keep a minimum distance of 50 cm to
the illuminated object.
WARNING When the spotlight is installed at a
place where people may walk or sit
under it, additionally secure it, e. g.
via a safety rope. Guide the safety
rope through the eyebolt on the rear of the
spotlight and fasten it in such a way that the
maximum falling distance of the spotlight will
not exceed 20 cm.
1. Install the spotlight via its mounting brackets,
e. g. with a stable mounting screw or a sup-
port for lighting units (C hook) on a cross bar.
To align the spotlight, release the two
locking screws of the mounting brackets.
Adjust the desired inclination of the spotlight
and fasten the screws.
2. Alternatively, set up the spotlight on its own:
Fold out the mounting brackets underneath
the spotlight and use them as a stand. Then
fasten the locking screws.

3.2 Barn doors

To reduce the light beam angle, optional barn
doors are available: PARC-100B. Fasten the
barn doors to the front of the spotlight.

3.3 Power supply

When the spotlight has been connected to the
mains, it is switched on. The display will show
the menu item most recently selected and go
out after 30 seconds. As soon as a button
(MENU, UP, DOWN or ENTER) is pressed, the
display will light up again for 30 seconds.
WARNING To prevent damage to your eyes,
never look directly into the light
source for any length of time.
Please note that fast changes
in lighting may trigger epileptic
seizures with photosensitive per-
sons or persons with epilepsy!

3.3.1 ODC-100 / RGB

Connect the plug (A) of the cable POWER IN
to the inline jack (B) of the mains cable pro-
vided. Then fasten the nut to secure this con-
nection.
POWER IN A
③
Mains connection ODC-100 / RGB
CAUTION! The cable POWER OUT carries
mains voltage. If no further unit is connected to
the cables POWER OUT and DMX OUT, always
screw the protective covers supplied onto the
inline jacks.
Connect the mains plug to a socket (230 V~/
50 Hz).
Power supply of multiple
ODC-100 / RGB spotlights
If multiple ODC-100 / RGB spotlights are used,
the units can be interconnected for power sup-
ply. For the time being, do not yet connect the
first unit to a mains socket.
1) Use the inline jack of the cable POWER OUT
to connect the first unit to the plug (A) of the
cable POWER IN of the second unit. Pro-
ceed in the same way to connect the second
unit to the third one etc. until all units have
been connected in a chain.
If the mains connection cables between
the spotlights are too short, use suitable
extension cables, e. g.
ODP-34AC
ODP-34AC / 10
CAUTION! To reduce the risk of cable fire
caused by overload, the total current in the
connection cables must not exceed 10 A.
Therefore, do not interconnect more than 19
ODC-100 / RGB spotlights.
B
230V~
length: 2 m or
length: 10 m
15