Multilaser RE034 Manual Del Usuario página 186

Adaptadores Wireless
Manually enable or cancel ICS.
Q3:
Failed to enable ICS.
A3:
Microsoft ICS service can only combine one group of WAN and LAN. This message
indicates ICS may have been enabled by other network adapters.
1. Please manually cancel or restart and cancel ICS, then re-switch to AP mode.
2. This dialogue box appears because virtual wi-fi miniport adapter can only be used
by one wireless network adapter at a time. Please disable any other non-Multilaser
wireless network adapters and re-switch to AP mode.
Q4:
Under Windows 7,when I switch from station mode to AP mode ,the screen
flashes"Disabling ICS, please wait......"and immediately return to station screen.
A4:
This is because you have disabled "Microsoft Virtual WiFi Miniport Adapter",please
re-enable it and then switch to AP mode.
Q5:
Client cannot obtain IP when connected to soft AP of the wireless network adapter.
A5:
Manually set an IP address at the same net segment as that of the AP and the
gateway and DNS at the IP address of AP.Thus, communication can be achieved.
Q6:
The SSID is not fully displayed on the wireless network list, what should I do?
A6: Keep the mouse on the displayed SSID for about 2 seconds, as the below picture
shows,and you'll see the full SSID on the appearing box.
186