Heraeus Kulzer Translux Wave Instrucciones De Uso página 49

Exposure 10 seconds polymerisation
Acoustical signal:
The following acoustical signals (beep) are emitted:
1 beep
1 beep
Exposure 20 seconds "Soft-Start" polymerisation
Acoustical signal:
GB
The following acoustical signals (beep) are emitted:
1 beep
- 14 -
1 beep
1 beep
1 beep
NOTE
Acoustical signal:
6.2 Measurement of the Light Intensity
CAUTION
Before each treatment always check the light intensity by using the light intensity meter
integrated in the Translux Wave charging unit.
GREEN LED
YELLOW LED
CAUTION
If the light intensity is insu cient, please carry out the following controls and measures:
Use original Heraeus Kulzer light guides only.
WARNING
If the measures described above do not result in any improvement, do not use the device for any treatment.
Switch o the unit (disconnect the charging unit from the electrical power source) and ensure that
unauthorised unit re-activation is not possible. Contact a Heraeus Kulzer's service partner, or technically
trained personnel authorised by Heraeus Kulzer (see paragraph 14 Service).
Start / Stop
Start / Stop
Start / Stop
Start / Stop
beep
Start / Stop
Start / Stop
Soft-Start
Start / Stop
2x
8
8