Controller; Operation; Operating Modes - Siemens PolyCool CPS 40 Manual De Instalación

+
-
Important
34/136
Siemens
Building Technologies
4

Controller

4.1 Operation

To operate the controller, use the operating buttons on the
controller front.
Press the <OK>
change.
Press the +/- button to change the flashing data, or select the
information screen.
Press the <ESC>
and return to the previous one.
By simultaneously pressing the buttons +, -, <ESC> and <OK>
for more than 5 seconds the controller gets reset to default
settings.
Reset function may only be carried out with the machine at a
standstill.
A flashing display indicates adjustable data.

4.2 Operating modes

The controller functions are divided into four operation modes:
regulation, configuration, parameter and simulation.
You can activate any desired mode by simulataneously pressing
the +/- buttons and holding them for a least five seconds. Release
the buttons when C1 is flashing.
Follow procedures below to access the operation mode, as
appropriate.
Operation modes
Configuration mode
Parameter mode
Simulation mode
CPS40
button to enable changes, or confirm a
button to exit out of the current level
Procedures
When C1 is flashing, press <OK> to
confirm.
Select the mode with +/-, and press
<OK> to confirm.
Or, press <ESC> to exit the current
operation level.
CE1U3372XX / H 74 319 0555 0 d
2013-10-01