Filling The Water Tank; Operation - Arctic Cove 500 CFM Manual Del Operador

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
UNDERSTANDING THE BASICS
The evaporative cooler is not an air conditioner. It does not
have a compressor and does not require refrigerant.
The unit works by pumping water away from the water tank
and distributing it across the filter media. The fan pulls warm
air from the rear of the unit and through the filter media. As
the air goes through the filter media, its warmth is absorbed
into the water. The fan then propels the cool and humidified
air through the front of unit and into the desired area.

FILLING THE WATER TANK

See Figures 6 - 7.
 Disconnect the evaporative cooler from the power supply.
 Ensure the drain plug is securely in place.
 Press and release the tank access door to open. The door
is located on the side of the evaporative cooler.
 Add water until the fluid level rises to the max fill line in
the sight window.
NOTE: Although tap water can be used, we recommend
using distilled or filtered water to reduce mineral deposits
which can clog the filter media.
 Close the tank access door.
NOTE: Always completely drain the water tank when the
evaporative cooler is not in use.
To drain:
 Move the evaporative cooler to an appropriate area where
any remaining water in the unit can be drained.
 Remove the drain plug and allow any water remaining in
the unit to drain out.
 Reinstall the drain plug.
WARNING:
When filling or draining tank, be careful not to spill water.
Ensure drain plug is securely in place when filling tank
and do not overfill. Spilled or leaking water can result in a
slippery surface, create a slip and fall hazard, and cause
property damage.

OPERATION

OPERATING THE EVAPORATIVE COOLER
See Figure 8 - 13.
WARNING:
Only move appliance in the complete upright position on
all four casters. Do not tilt or tip over appliance; tilting or
tipping unit can cause water to spill, resulting in possible
electric shock, slip and fall hazard, or property damage.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
WARNING:
Do not use the evaporative cooler to disperse liquid
medicines, chemicals, or any liquids other than clean
water. These substances could result in serious injury or
illness to the operator or bystanders.
 Connect the evaporative cooler to the power supply.
 To allow for proper ventilation and optimal cooling, place
the unit in front of an open window and leave the door to
the room slightly open.
NOTE: When the unit is in the desired position, press
down on the wheel lock to secure the casters in place
and prevent the unit from moving during use.
To turn the evaporative cooler on/off:
 Press the POWER button on the control panel or remote
control. When the unit is on, the digital display will be
illuminated.
 To turn the unit off, press the POWER button again.
NOTE: It is normal for odor to be emitted from the filter
media during first use. The smell will dissipate after a few
hours of operation.
To adjust the fan speed:
 Press the FAN button on the control panel or remote
control. Each time the FAN button is pressed, bars will
appear above the fan icon (
indicating high (
To turn the pump on and off:
 Press the COOL button on the control panel or remote
control. The cool icon ( ) will appear in the digital display.
NOTE: When the pump is on, water will be pumped into
the filter media, which will have a cooling effect on the
air flow.
8 — English
) in the digital display
), medium ( ), and low ( ) speeds.