Cleaning And Storage - Murray SPRINT Manual De Instrucciones

3. Turn the reel blades slowly by hand in the direction shown by the arrow in figure 6 and check
if the paper is cut as the first reel blade passes. Repeat this process for the entire length of the
fixed blade and the paper should cut cleanly and evenly. The blades act like a scissor.
4. If the paper is not cut cleanly and evenly, use a 4mm Hex Allen key (D) and turn it clockwise
approximately 1/8th of a turn to tighten the adjustment bolt (E) on both side until the reel blades
lightly brushes the fixed blade.
5. If the reel blades and fixed blade make in contact and it becomes difficult to turn the reel blades
by hand, use hexagon allen key and turn it anticlockwise to loosen the adjustment bolt on both
sides. Repeat step 2 & 3 for checking.
NOTE:
• The adjustment bolts should be equally adjusted to avoid misalignment between the reel blades
and the fixed blade.
• Do not overtighten the adjustments bolts as this could damage the fixed blade.

Cleaning and Storage

• Clean the mower thoroughly after each use using a soft brush.
• Do not use water, solvents, polishes or any aggressive cleaning agents.
• Do not immerse the mower or any part of it in water.
• Store the mower in a dry place.
• Do not place other objects on top of the mower during storage.
The mower is not freestanding and care should be taken to ensure the
mower does not tip, fall or roll during storage.
Troubleshooting
Problem
Poor cutting Worn or damaged blades
Irregular walking pace.
Blunt blades
Clearance between the reel blades and the
fixed blade is too wide
Abnormal noises Worn or damaged blades
Loose fasteners
Interference between the reel blades and the
fixed blade is too much
Difficult to push Worn or damaged blades
Cutting height adjustment is too low
Interference between the reel blades and the
fixed blade is too much
Blades restricted by grass and dirt
accumulated around the cutting area
Possible cause
MAINTENANCE
Correction
Contact Service Centre
Walk at a good, steady pace
Contact Service Centre
Refer to 'Adjusting the Blade'
Contact Service Centre
Retighten or replace
Refer to 'Adjusting the Blade'
Contact Service Centre
Raise cutting height adjustment
Refer to 'Adjusting the Blade'
Clean the cutting area
EN
11