Removing And Refitting The Cover; Cleaning Instructions - BESAFE STOKKE IZI GO MODULAR X1 Instrucciones De Uso

Head cushion
Remove the head space reducers on both sides from the headrest cushion when the child
is older then 3 months or if the head is not fitting anymore or when the baby has a stature
height higher then 60 cm. (18) (Not on all models).
Using the Stokke® iZi Go Modular™ X1 by Besafe® with a stroller from Stokke
The Stokke® iZi Go Modular™ by BeSafe® can only be used on the following strollers:
Stokke® Xplory®, Stokke® Crusi™, Stokke® Trailz™, Stokke® Scoot™ and Stokke® Beat ™.
Installation on a stroller (19)
Align the stroller adapter house above the adapters of the stroller and move straight down,
click (2x) ! Green dots on both sides indicate that the seat is properly fastened.
• The car seat should always be facing the parent (20).
Removing from a stroller (21)
• Move the carrying handle into carrying position.
• Push the stroller release up at both sides while lifting the seat vertically from the stroller.

Removing and refitting the cover

• Do take care when you remove the cover, as re-fitting the cover is done in reverse.

Cleaning instructions

The covers of the Stokke® iZi Go Modular™ by BeSafe® must be washed in accordance with
the instructions on the inside of the covers. Clean harness by hand with water and mild soap.
Warning: potential misuse
• The child seat MUST NOT be installed in a front passenger seat
WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that the floor support
is fully pushed down.
• Make sure the indicators are green before you drive.
EN
14
Stokke® iZi Go Modular™ X1 user guide
Guarantee
• Should this product prove faulty within 24 months of purchase due to materials or
manufacturing fault, except covers and harness straps, please return it to the original
place of purchase.
• The guarantee is only valid when you use your seat appropriately and with care. Please
contact your retailer, they will decide if the seat will be returned to the manufacturer for
repair. Replacement or return cannot be claimed. The guarantee is not extended through
repair.
• The guarantee expires: when there is no receipt, when defects are caused by incorrect and
improper use, when defects are caused by abuse, misuse or negligence.
Stokke® iZi Go Modular™ X1 user guide
EN
15