Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL LE 16 Manual De Instrucciones

9. Cleaning, maintenance and
ordering of spare parts
Be sure to pull out the power plug before
doing any maintenance and cleaning work!
•
Use only a soft cloth to clean the casing.
•
Do not use any aggressive chemicals, deter-
gents, chemically treated cleaning cloths or
solvents. They could damage the casing.
Cleaning the air fi lter (every 2 weeks)
•
Remove the air inlet grille (Fig. 5 / Item 7) and
then the air filter washer (Fig. 5 / Item 6).Use
a vacuum cleaner.
•
If the filter is very dirty, wash it with warm wa-
ter (max. 40°C). Then allow it to dry thorough-
ly. Never expose the filter to the sun or other
sources of heat. Never reinsert the filter while
it is still damp.
Maintenance
•
There are no other parts inside the equipment
which require maintenance.
Storage
If you are not going to use the dehumidifi er for
some time, proceed as follows:
•
Switch off the equipment, pull out the power
plug and roll up the power cable. (fig. 5/Pos.
D)
•
Empty the water collector and dry it thorough-
ly.
•
Remove the rubber plug as described in sec-
tion 8 and tilt the device slightly to remove any
remaining water.
•
Clean the ventilation grille and the dust filter
cover the equipment and store it in a dry and
dust-free place.
Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Anl_LE_16_20_30_SPK7.indb 17 Anl_LE_16_20_30_SPK7.indb 17
GB
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
11. Troubleshooting
•
The equipment does not start:
- Check whether the power plug has been
inserted properly.
- Is there a power failure?
- Is the red lamp of the water level indicator
lit? If it is, the water collector is full and must
be emptied or the collector is not inserted
properly.
- Do the room conditions lie within the opera-
ting range (see Technical Data)?
•
The equipment does not seem to be wor-
king:
- Is the fi lter soiled?
- Is the air supply line or exhaust line blo-
cked?
- Is the room's humidity already very low?
•
The equipment seems to be working very
poorly:
- Are too many doors and windows open?
- Is something in the room producing too
much humidity?
•
The equipment is very loud:
- Is the equipment vibrating because it is not
standing squarely or is tilted?
- Is the fl oor uneven?
Important. Never try to repair the equipment
yourself. Contact your customer service
center.
- 17 -
24.02.16 08:33 24.02.16 08:33