Installation
3.4 Connecting to the drain
In products equipped with condenser unit, water
accumulates in the water tank during the drying cycle.
You should drain accumulated water after each drying
cycle.
You can directly drain accumulated water through the
water drain hose supplied with the product instead of
periodically draining the water collected in the water
tank.
Connecting the water drain hose
1-2 Pull hose at the behind of the dryer by hand in
order to disconnect it from where it is connected.
Do not use any tools to remove the hose.
3
Connect one end of the drain hose supplied with
the dryer to the connection point from where you
removed the hose of the product in previous step.
4
Connect the other end of the drain hose directly to
the wastewater drain or to the washbasin.
1
3
A
Hose connection should be made in a safe
manner. Your drain house will be flooded if the
hose comes out of its housing during water
discharge.
C
Water drain hose should be attached to a
height of maximum 80 cm.
C
Make sure that the water drain hose is not
stepped on and it is not folded between the
drain and the machine.
12 / 80 EN
2
4
3.5 Adjusting the feet
•
In order to ensure that the dryer operates more
silently and vibration-free, it must stand level and
balanced on its feet. Balance the machine by
adjusting the feet.
•
Turn the feet to left or right until the dryer stands
level and firmly.
C
Never unscrew the adjustable feet from their
housings.
3.6 Electrical connection
For specific instructions for electrical connection
required during installation (see 1.1.1 Electrical
Safety)
3.7 Transportation of the dryer
Unplug the dryer before transporting it.
Drain all water that has remained in the dryer.
If direct water drain connection is made, then remove
the hose connections.
We recommend carrying the dryer in
A
upright position. If it is not possible to carry
the machine in the upright position, we
recommend carrying it by tilting towards the
right side when looked from the front.
Dryer / User Manual