Additional Information - Pioneer VMS-550 Manual De Instrucciones

4. Additional information

Troubleshooting
If you run into any problems using this speaker system, refer to the following
checklist.
Incorrect operation may result in some problems. In addition, the problems may
be caused by malfunctions on the components connected to this system. Should
any problem persist, consult your nearest Pioneer authorized service centre or
your dealer to carry out repair work.
When visiting your Pioneer authorized service centre for repairs, be sure to take
both the speaker and transmitter.
Problem
No sound.
Sound intermittent.
Sound is distorted.
10
En
• Check the connection between the AC adaptor
and the wall outlet.
• Check the connection between the transmitter
and the AV components.
• Start playback after checking that the power is
turned on for the TV or audio playback device
used.
• Check the batteries are placed in correct
polarities.
• Batteries are completely used up.
• Confirm that the speaker's POWER indicator
and the transmitter's STANDBY/ON indicator
are lit green. If the speaker's POWER indicator
is not lighted, recharge the speakers.
• Raise the sound volume. If no sound can be
heard even when the sound volume is raised,
lower the sound volume again and try the other
suggestions here.
• Press the speaker's TUNED switch to match
the transmitter's frequency channel.
• Change the transmitter's frequency to a
channel with better reception conditions.
• Bring the speakers and transmitter closer
together. Also, do not allow any obstacles to
come between the speakers and transmitter.
• The sound volume control is set too high, or too
low at the TV/AV or other playback source. Try
adjusting the sound volume of the playback
device.
Remedy