The appliance is supplied with the following filters:
Solids filter (R): this filter performs an initial filtration of
•
deposits and material of considerable size. The curves
located at the ends can be removed for easy cleaning.
Check and wash with running water. Reinstall the curves
by pressure-fastened them; notice that the position of the
curves is forced by a special rib and housing.
Microfibre filter (P): This filter has a high filtering capa-
•
city and allows you to vacuum up dust effectively. It is
very convenient for when you want to use the appliance
quickly because the dust remaining in the tank (M) is not
in contact with water and therefore does not need to be
rinsed out immediately after use. To remove it, wash
from the inside out under running water then leave it to
dry before reassembling the filter group.
IMPORTANT: The microfibre filter (P) should not be used
during the vacuuming with water filter.
Sponge filter (Q): The Sponge filter (Q) is to be used for
•
vacuuming dust, vapour and liquids with the water filter
for more thorough cleaning. Wash with running water
from the inside out and let it dry before putting back
the filter assembly.
Air filter (X): this filter has a high filtering capacity and
•
can filter fine dust, thereby ensuring clean air coming
out of the appliance. Check it periodically by lifting the
hooker lever.
(picture 35)
Carbon filter (Y): this filter has a high filtering capacity.
•
It blocks the motor carbon dust that is produced during
operation. Check it monthly by removing the con-
tainment screen and, if necessary, replace it when dirty.
CAUTION! Handle with care - Do not inhale - Keep out of
reach of children
Water filter employs the natural purifying strength of
•
tap water to catch the dirt, avoiding irritating contact
with dust and harmful dispersion of dust into the envi-
ronment.
EN
FILTERS
(picture 32)
(picture 33)
(picture 34)
picture 32
picture 33
picture 34
picture 35
picture 36
picture 37
12