SmartPool SUNHEATER S601 Manual De Instalación Y Operación página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION & MAINTENANCE
Operation
1. The collectors should feel cool to the touch when the sun is shinning on them and water is passing through. This means that the
heat is being transferred to the water.
2. The water returning to your pool will be a few degrees (3-5degrees) warmer than the pool itself. This is the most efficient
way to heat a large body of water like a pool. Keep circulating the water, which adds a few degrees each pass.
3. Circulate water though the solar collectors at least 6 hours per day during the daylight hours on sunny days. If you circulate
water through it at night, when it's overcast or on chilly days, you will cool your pool water rather than heat it. If you need to
run your pump at night, divert the water directly back to the pool and bypass the solar system. An automatic controller will sense
the water temperature and available radiation from the sun and automatically turn the 3-Way Valve to direct the flow of water
accordingly. Contact your local dealer or SmartPool at 888-560-7665 for purchasing details.
Winterization
YOUR SOLAR SYSTEM MUST BE DRAINED FOR WINTERIZATION! FREEZE DAMAGE IS NOT
COVERED UNDER WARRANTY! YOU MUST DRAIN YOUR SOLAR COLLECTORS JUST LIKE
YOU DRAIN THE REST OF YOUR POOL EQUIPMENT!
Remove the vacuum relief valve at the top of the solar system. Remove the rubber end cap at the bottom and be sure ALL the
water is drained out of the system. Replace end caps and blow pressurized air in the reverse direction of normal water flow. This
is the most effective way to drain your system. You can leave the collectors in place (as long as they are completely drained) and
they will withstand even the harshest winters. Of course, you can store your collectors inside in a warm dry place. if you like.
Collector Repair
IF A COLLECTOR DEVELOPS A LEAK
Your solar collectors are warranted against defects in materials and workmanship.
If a leak develops for any other reason, you may use the repair method shown.
The collectors are not warranted against freeze damage.
SOLAR COLLECTOR REPAIR
This method allows for an easy and permanent, on-site repair of a collector by
isolating the leading riser tube. Referring to the figure at the right, locate the
tube to be isolated. (End tube has been shown for clarity). Using a sharp
utility knife, very carefully cut away approximately 1" of the tube at both
headers. Drive a #10 sheet metal screw, preferably stainless, into the
hole in the header. The screw must be between 1/2" and 3/4" long.
DO NOT OVERTIGHTEN! If the screw strips out, or if the repair leaks,
use a #12 screw. This repair method will not void the collector warranty.
With proper care and winterization, you will enjoy your solar collectors for many years.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido