Publicidad
ELECTRONIC DESIGN
Fig.1
RJ14
4 wires cable
(max 3m long)
Fig.2
ENGLISH
TIME-OUT Signaller
R
Acoustic buzzer and light signaller for
requesting Time-Out in volley-ball.
User manual
OPERATION
By pressing the operation button on the Time-
Out signaller the buzzer will activate for 1.5
seconds and the light will begin blinking for the
programmed time (predefined at 18 seconds).
To regulate the blinking light for a shorter or
longer time, hold down the operation button for
10 seconds + the time you want the light to
blink. For example, if you want the light to blink
for 20 seconds, hold down the button for
10+20=30 seconds.
You can programme the light to blink for 5 to
90 seconds. A value less than 5 seconds or
greater than 90 seconds will not be accepted
and the previous programmed time will remain
valid.
BATTERIES AND REPLACEMENT
The signaller comes provided with 2 common
alkaline 9V batteries (6LR61 format).
Battery life is approximately 1,600 operations
lasting 18 seconds each.
To replace batteries:
1. Unscrew the 6 screws shown in fig. 1 and
open the container.
2. Remove each battery along with the foam
rubber stopper.
down at the base of the battery freeing the
end nearest the connections.
3. Insert the new batteries along with the foam
rubber stopper.
4. Close and fasten the container.
REMOTE CONTROL OPERATION BUTTON
A remote control button can be connected (see
fig. 2) by inserting a common telephone cable,
Push
along with a RJ14 (6P4C) plug, into the proper
button
connector located at the bottom of the
signaller.
(art.254)
For easy removal, push
Publicidad
