ci LOP G3 Guia Del Usuario página 10

Plug in the power plug and
4
press Power, then press Start/
Pause button. It will pre-heat while
flickering red light.
After 1 minute it will illuminate
5
green light, and the ingredients in
the hopper will automatically drop
into the drum and begin pressing
oil.
Maximum operation time is 25
6
minutes. Turn off the machine every
25 minutes and use it again after
10~20 minutes.
When the appliance is operated
7
for over 45 minutes or ingredients
not added for 1 minute, it will turn
to protect mode and the red light
will flicker. Press the Power button
again to use it.
After 5 minutes in the protect
8
mode, it will automatically shut
down.
If the ingredients are too big, it
could stop automatically. In this
case, turn off and then turn back on,
and press Start/Pause.
When the auger is clogged, it
will automatically stop and go into
protect mode. In this case, press
Reverse for few seconds, and
Start/Pause.
Left over residue remaining on the
auger could turn hard and cause
malfunction. To prevent this kind
of event, please follow the below
instructions.
DISASSEMBLY
Remove the hopper, turn the
1
drum locking lever from lock to
unlock.
Lift up the protection cover.
2
Pull out the drum away from the
3
appliance.
Pull out the auger away from
4
the appliance. Make sure it has
completely cooled down, as it could
be very hot and cause injuries. Use
glove if required.
18
Use a soft cloth to clean the
5
auger and drum.
After use, drum could not be
separated due to residue stuck
between the auger and drum. In this
case, slightly shake the drum up and
down.
ASSEMBLY
When assembling, make sure
1
auger is installed before the drum.
Turn the drum locking lever from
2
unlock to lock. When the lever is
stuck or doesn't full goes to lock,
do not force it, but try to assemble
the auger and shaft again and then
lock it.
Pull down the protection cover.
3
19