Safety Regulations; Layout And Items Supplied - EINHELL TE-CC 250 UF Manual De Instrucciones Original

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1-23)
1 Sawing table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Complete parallel stop
8 Hand wheel
9 Adjusting and locking grip
10 Base frame
11 On/Off switch
12 Eccentric lever
13 Adjustable rubber foot
14 Cross stop
15 Screw
16 Extractor adapter
17 Countersunk head screw
18 Hole (splitter)
19 Fastening screw
20 Screw
21 Groove
22 Scale
23 Stop rail
Anl_TE_CC_250_UF_SPK9.indb 21 Anl_TE_CC_250_UF_SPK9.indb 21
GB
24 Holder
25 Slot
26 Screw
27 Slot
28 Guide rail
29 Mounting plate
30 Splitter counter bearing
31 Wheel
32 Holder for parallel stop
33 Table width extension
34 Tool hook
35 Lever
36 Nut
37 open-ended spanners
38 open-ended spanners
39 Table extension
40 Flange
41 Overload switch
42 Cable store
43 Slide
a Screw
b Locking screw
c Lever
d Washer
e Screw
f Axle screw
g Washer
h Spacer tube
i Nut
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 21 -
15.10.2019 15:25:11 15.10.2019 15:25:11