EN
11. Unplug the product ...
- when the product is not being used,
- in case of malfunctions,
- before attaching / detaching accessories and
- before cleaning the product.
12. Check the power cord and housing on damages. Should any damages found, do not use hairdryer
anymore, and have the hairdryer repaired by a qualified electrician before using it again.
13. Do not bend or crush the power cord; always position it so that no-one can step or trip on it.
14. Do not wrap the power cord around the hairdryer and protect it from damage.
15. Do not use an extension cord.
16. Never touch the hairdryer, power cord or plug with wet hands.
17. Disconnect your hairdryer from the power supply immediately after use. The appliance is only
completely switched off when it has been unplugged.
18. Use this product in dry indoor areas only and never outdoors.
19. Place the product on a flat, sturdy and slipresistant surface.
20. Never use, expose or put the product near to:
- direct sunlight and dust;
- fire (fireplace, grill, candles), water (water splashes, vases, ponds, bath tube) or heavy moisture.
21. This product is not intended for commercial use. It is designed for household use only.
22. Should the product fall into water, then unplug the power cable from the mains outlet. Do not reach
into the water before the product has been disconnected from the mains supply. Get the product
checked by an expert at this stage.
23. If you are using the product with your hand(s), then always make sure it is turned off for safety
reasons.
24. The air outlet grill may become very hot during use. Make sure that the power cable does not come
into contact with the air outlet grill.
25. The air inlet screen can be come hot during operation. Make sure that the power cable does not
come into contact with the air inlet screen.
26. Never open the housing. Do not place any objects inside the air inlets and outlets.
27. Make sure that any objects such as hairpins or hair clips do not get inside the product. This may cause
a short circuit or damage to the product.
28. Allow the product to cool down completely before you remove or install any accessories.
29. Do not use sprays or water sprays in close proximity of the product.
30. Never cover the air inlet and outlet openings during use. Make sure that any hair does not come into
contact inside the air inlet and outlet openings.
31. Should the air inlet and outlet openings be covered during operation, then the built-in thermal
protection will automatically switch the product off. Pull the plug and allow the product to cool
down completely before setting it back in motion. Check to see whether the air inlet screen has
become dirty, and remove any debris such as hair or fluff.
32. Risk of burning! Parts of the product may become very hot during operation. Hold the product
therefore only with the handle.
33. Clean the product and all other accessories after each use.
IM_OHA105R_190624_V05_HR.indb 8
8
24/6/19 11:49 am