Changing Batteries - OK. OSF 443-W Manual De Instrucciones

EN
ASSEMBLING AND MOUNTING
1 Assemble the two foot parts crosswise. Remove the four screws from the foot parts.
2 Use the four screws to mount the extension pole onto the feet. Then remove the height adjustment
ring.
Slide the stand cover over the extension pole onto the feet. Pull out the extension pole and secure
3
it by installing and fastening the height adjustment ring.
4 Attach the motor unit to the extension pole and secure it with the screws.
Remove the spinner and the plastic nut from the motor unit. Attach the rear guard to the motor
5
unit.
Secure the rear guard with the plastic nut.
6
Slide the fan blade onto the motor shaft so that the pin locks to the groove. Secure the fan blade by
7
tightening the spinner onto the shaft.
Open the clips on the front guard. Hook the front guard onto the rear guard, thereby aligning the
8
screw holes at the bottom of the guards.
9 Install the screw and nut to lock the guards. Make sure all the clips are closed.
10 Place on a stable level surface. Set the desired angle and height.
OPERATION
11 Plug in the product.
12 Press ON/OFF to switch the fan on. Press SPEED repeatedly to cycle through the fan speeds
(L=Low; M=Medium; H=High). Alternativ you can use the button
the speed. Press
13 Press TIMER or
repeatedly to set the hours (1, 2, 4 hours) after which the fan should turn off.
14 Press the OSCILLATION / SWING knob to activate oscillation function.
Caution
• The product may only be connected to the mains once it has been completely assembled.
• The appliance must not be disassembled during operation, general care, cleaning and user
maintenance.
• The product may never be operated without the stand or in a horizontal position.
• Switch off and disconnect the product before adjusting height or desired angle.
• The guard must be completely closed when operating the product.
• During operation, do not put fingers or other objects in the guard.
• Unplug if it is not used for some time.

CHANGING BATTERIES

15 Open the battery compartment of the remote control. Insert 2 batteries (not included) of type
LR03 (AAA) observing the + and – polarities as indicated on the batteries and inside the battery
compartment. Close the battery compartment.
IM_OSF443-W_151103_V03_HR.indb 16
button to turn on/off the product.
button on the remote control for timed operation. Press TIMER or
16
on the remote control to select
button
3/11/15 9:58 AM