König SAS-ALARM320 Manual De Usuario página 4

SAS-ALARM320
Alarm system
Package contents
1. Central alarm unit
2. PIR motion detector
3. Door/window detector
4. Remote control
5. RFID-tag
6. AC adapter
Central alarm unit (Fig. A)
• The LED indicator flashes once every second: The
alarm system is searching for the GSM network.
1. GSM indicator
• The LED indicator flashes once every 3 seconds:
The alarm system is connected to the GSM network.
• The LED indicator is off: The alarm system is not
armed.
2. System Status
• The LED indicator is on: The alarm system is armed.
indicator
• The LED indicator flashes: The alarm system is in
home mode.
• The LED indicator is off: No new voice memo.
• The LED indicator flashes: There is a new voice
3. Voice memo indicator memo.
• The LED indicator comes on after pressing the
voice memo button.
4. Display
5. Emergency button • Press the button to activate the alarm immediately.
• To disarm the alarm hold the RFID-tag over this
6. RFID-tag reader
area.
7. Arm alarm button • Press the button to arm the alarm system.
• Press the password followed by this button to
8. Disarm alarm button disarm the alarm system.
Note: The default password is 1234.
• Press the button to partially arm the alarm system.
9. Home arm alarm
The alarm system stops handling alarm signals
button
from sensors in the home zone.
• Enter the phone number and press the button to
10. Call button
dial.
• Press and hold the button for 3 seconds to leave a
11. Voice memo button 10-second voice memo.
• Press once to listen to the new voice memo or to replay.
• Release the button to activate the alarm immediately.
• You can activate or deactivate this function by
sending an SMS to the SIM card number of the
12. Tamper switch
control panel with the following text:
"87201": Activates the function
"87200": Deactivates the function
• Press the button to switch on or off the central
13. On/Off button
alarm unit and the alarm system.
14. SIM card slot • Insert the GSM SIM card in the SIM card slot.
• Option to connect an existing electronic lock to
15. Electronic lock output
• Connect the control panel to the DC input for long
16. DC input
PIR motion detector (Fig. B)
1. Detector
2. Detection window
• The LED indicator flashes continously: Self-test
• The LED indicator flashes once: The detector is
3. LED indicator • The LED indicator flashes twice: The self-test mode
• The LED indicator flashes once every 3 seconds:
• Arm the alarm system.
• Press the test button until the alarm is triggered.
4. Test button
5. Zone setting
(inside the detector)
Door/window detector (Fig. C)
• Install the transmitter to the frame of the door or
1. Transmitter
• The LED indicator flashes once: The transmitter is
2. LED indicator
• The LED indicator flashes once every 3 seconds:
• Install the magnet to the door or window using
3. Magnet
• When the tamper switch is released, the system
4. Tamper switch
5. Zone setting
4
the alarm system.
usage or for charging.
mode.
triggered and sends a signal to the control panel.
is completed. The detector enters power-saving
mode.
Low battery. Replace the battery.
Note: The self-test mode will be completed after 3
minutes.
window using double-sided adhesive tape or
screws.
triggered and sends a signal to the control panel.
Low battery. Replace the battery.
double-sided adhesive tape or screws.
Note: Make sure that the magnet is aligned
correctly to the transmitter (markings on the
magnet and the transmitter) within 1 cm from
each other.
will arm immediately.