Restarting The Network - Siemens Gigaset WLAN Repeater 108 Manual De Instrucciones

Restarting the network

ì
Restart your Gigaset WLAN Repeater 108 by disconnecting the mains plug and plug-
ging it in again.
ì
Check that the Power LED on the front panel of the unit is on continuously.
ì
Restart your PC.
You have now configured and opened a link between your PC and the Gigaset WLAN
Repeater 108.
Configuring the Gigaset WLAN Repeater 108
In order to use the Gigaset WLAN Repeater 108, you must make some further configu-
ration settings depending on the mode.
For the initial configuration we suggest that you connect the Gigaset WLAN Repeater
108 with an Ethernet cable to the Ethernet port of the PC on which you wish to make
the configuration.
Configuring is done with an Internet browser.
Please remember:
If you want to use the Gigaset WLAN Repeater 108 in Operating Mode Ethernet adapter,
please read the information on page 20 first.
Launching the configuration program
ì
Switch on your PC.
ì
Open your Internet browser. Delete any address that may already appear on the
address line.
ì
On the address line, enter the address 192.168.2.254 and press the ENTER key.
You will now see the login page of the configuration program.
If you see the error message "This page cannot be displayed" instead of this screen,
please check that you have typed the address correctly, make sure that your browser is
not in offline mode and deactivate any other LAN connections of your computer.
ì
At the time of delivery, admin is the default password. Enter this password and click
on OK.
After a few moments you will see the start screen of the configuration programme.
ì
Run the basic settings wizard by clicking on the area marked Basic Setup or select
the entry with that name in the menu bar.
The basic settings wizard will take you through the configuration procedure step by
step.
It is strongly recommended that you carry out the security settings after completing the
basic settings.
Quick Start Guide
19