PIN CODE PERSONALISATION:
The PIN CODE is supplied by default set with random values. The user, as soon as disposing of the
system installed on-board the vehicle, will personalise it to increase the system's intrinsic safety.
NOTE:
After changing the PIN CODE, the client will store this code in order to be always available in case of
emergency, but never accessible to people non-authorised to operate the vehicle.
The procedure to personalise the pin code is the following:
1. Enable and disable the vehicle's activation panel three times.
2. Upon the third activation (leaving the panel enabled), the LED will emit a series of flashing to notify
the input in programming mode.
3. Wait approx. 0.5 sec. between one activation and the other of the panel.
4. Within 5 sec., press key B of the remote control, the alarm will emit two sound signals.
5. The led will begin to emit a series of flashing, as soon as the number of flashing reaches the first
digit of the pin code to personalise, press key A of the remote control to confirm the value; the alarm
will confirm the digit by emitting a sound signal.
6. After approx. 2 sec., the led will begin to emit again a series of flashing, as soon as the number of
flashing reaches the second digit of the pin code to personalise, press key A of the remote control to
confirm the value; the alarm will confirm the digit and the end of the procedure, by emitting a sound
signal.
7. The led will no longer flash, thus confirming the successful programming of the PIN CODE.
8. Turn off the vehicle's activation panel.
The pin code can be modified as many times as required.