Tabla de contenido
Publicidad
1
6
5
3
WHAT IS WHAT?
1. Throttle trigger
2. STOP switch
3. Primer button
4. Choke lever
5. Fuel cap
6. Starter rope
CARTON CONTENTS
Check carton contents against the following list.
S Blower
S Upper blower tube
S Lower blower tube
S High velocity nozzle
NOTE:
It is normal for the fuel filter to rattle
in the empty fuel tank.
ASSEMBLY
WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING:
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure. Fol-
low all safety information in the manual and on
the unit.
A standard screwdriver is required for as-
D
sembly.
BLOWER TUBE ASSEMBLY
1. Align the rib on the upper blower tube with
the groove in the blower outlet; slide the
tube into place.
NOTE:
The tube clamp bolt must be loose
enough to allow blower tube to be inserted in
blower outlet. Loosen the bolt by turning coun-
terclockwise (do not remove nuts).
WHAT IS WHAT?
2
7
4
7.
Spark plug
8.
Upper blower tube
9.
Lower blower tube
10. High- -speed nozzle
11. Instruction manual
ASSEMBLY
If received assembled,
8
2. Secure the tube by turning the bolt clock-
wise.
3. Align the slots on the lower blower tube
with the tabs on the upper blower tube.
Upper Blower
Tube
Tube
clamp
bolt and
nut
4. Slide the lower blower tube onto the upper
blower tube.
5. Turn the lower blower tube clockwise until
a click is felt to secure the lower blower
tube to the upper blower tube.
NOTE:
When the upper and lower blower
tubes are assembled together properly, the
arrows on both tubes will be aligned.
-- 4 --
9
Blower Outlet
Rib
Groove
Lower Blower
Tube
Tab
Slot
10
11
Publicidad
Tabla de contenido
