Hayward ColorLogic 320 Manual Del Usuario página 16

Operation
Operating the ColorLogic 320
®
The ColorLogic 320 light is controlled through power-cycling: a method of changing light programs which requires no special
®
controller or interface. To activate the light, simply turn on the switch. To deactivate the light, turn off the switch. To advance
to the next light program (fixed color or color show), turn the switch off, then back on within 10 seconds.
When the light has been off for over 60 seconds, and is first turned on, it will come on to white for 15 seconds for quick clear
view of your pool, then go to the last fixed color or color show it was running.
Light Synchronization
If your pool or spa has multiple Hayward ColorLogic 320 LED lights, they may be operated independently, or they can be
®
easily synchronized so they will all display the same colors and shows at the same time. For light synchronization, all lights
must be wired to the same switch. Once installed, all lights should be automatically synchronized, however, if they get out of
sync, they can be re-synchronized easily.
To re-synchronize your lights, start with the lights off and follow the steps below:
1. Turn lights on.
2. Turn off light for between 11-15 seconds,.
3. Turn lights on.
When the lights come on, they should enter program #1 (Voodoo Lounge), and be synchronized.
Programs
The ColorLogic 320 light has the capability to display 17 different programs; 10 fixed colors and 7 color-changing shows.
®
These programs are advanced using power-cycling (quickly powering the lights on, then off, then back on). The programs
are listed below:
1. Show-Voodoo Lounge
2. Fixed-Deep Blue Sea
3. Fixed-Royal Blue
4. Fixed-Afternoon Skies
5. Fixed-Aqua Green
6. Fixed-Emerald
7. Fixed-Cloud White
8. Fixed-Warm Red
9. Fixed-Flamingo
10. Fixed-Vivid Violet
11. Fixed-Sangria
12. Show-Twilight
13. Show-Tranquility
14. Show-Gemstone
15. Show-USA
16. Show-Mardi Gras
17. Show-Cool Cabaret
USE ONLY GENUINE REPLACEMENT PARTS
Page 7 of 8 Rev. A
ColorLogic 320
®