HSM SECURIO P 44 Instrucciones De Servicio página 16

Problem
Cutting unit runs con-
tinuously even though
the machine is not in the
permanent mode.
Display
Several indicators are lit
Display Problem
Oil reservoir
empty
Display Function
Button lock
is activated
Notes
Manual reversing
If you press the reverse button, the cutting unit
runs in reverse and switches off after 2 sec-
onds, even if you keep the button pressed. To
reverse manually, release the button and press
it again.
If the shredder is already running forward,
pressing the button immediately reverses it.
Shredded material container
Both cutting units stop when the paper or CD
container is full.
On machines with a separate CD cutting unit,
the level in the CD container (see overview,
item 7) is monitored. Empty the container after
there is a signal on the operating and indicator
element.
16
The light barrier is soiled with paper dust.
• Clean the light barrier in the paper feed using a dry brush or cloth.
Indicator
The R button was pressed for more than 20 s.: Software version display (for
service technicians only)
Measure
• Fill the reservoir with cutting apparatus oil.
1
2
Activate/deactivate
To activate or deactivate the button lock
• Press and hold the reverse button
• Press the on/off button
• Release the on/off button and then the R button
SECURIO P 44
Only use HSM special oil.
Reservoir volume: 250 ml
Press the safety element and lift up the fl ap.
The oil fi lling opening is to the right of the feed chute.
You can fi ll the oil either through the small opening
1 (take out the yellow plug) or the normal opening 2
(unscrew the red cap).
Automatic oiler (cross cut only)
The cutting units are oiled for 1.5 seconds after:
• The cutting unit is in operation for 200 sec-
onds (corresponding to 50 paper shreds)
• The cutting unit runs forwards after the re-
verse button has been pressed
The "Oil reservoir empty" signal is automati-
cally deactivated after the reservoir is fi lled. The
shredder remains operational even when the oil
reservoir is empty.
Metal detection (optional)
The document shredder can be optionally
equipped with a metal detector. The automatic
switch-off allows damage to the cutting unit by
paper clips or other metal objects to be avoided.
Safety element monitoring
Movement of the safety element was detected
during the shredding procedure. If your ma-
chine switches off without signalling an error,
english
12/2014