Risk Analysis - Evco EV3B23 Manual De Instrucciones

RISK ANALYSIS

List of hazards:
- Electrical parts
- Sharp parts
- Machine handling
- Fans in motion
- Inflammable gas
- Refrigerant gas
- Airflows
- Non-drinkable water
- Contamination of food
- Non-accessible gas pipes
- Accessible gas pipes
- Lamps
- Cold environments
- Slippery floor and footboard
- Glass or Plexiglas parts
- Plexiglas cover in motion
Warning related to hazard of electrical parts: Risk of electric shock, burning, and fire:
- Access to electrical parts must be entrusted exclusively to qualified technicians.
- Do not touch the machine with wet hands or feet.
- Do not operate the machine in bare feet.
- Do not insert your fingers or objects through the gratings or air vents.
- Do not pull the power cable.
- Do not wash the machine with water jets.
- Disconnect the machine from the electrical line during maintenance or cleaning.
- If the machine is flooded with water, contact an authorised assistance centre to repair it before using the appliance
once again.
- If the machine is not used, pull out the plug.
Warnings related to general hazards. Risk of injury:
- Presence of sharp parts. Use suitable protective gloves for operations on the machine.
- The machine must be handled with care with appropriate means and attention to avoid harm to persons or objects.
- Presence of fans in motion. Do not remove the protective gratings.
- From the machine's identification label, read the type of refrigerant gas, it may be inflammable gas.
- If flammable gas leaks from the refrigerant circuit of the machine, disconnect the cable from the power supply, open
the windows to ventilate the room and contact technical assistance immediately.
- If refrigerant gas should leak, do not touch or inhale it.
- After installation or repairs on the machine, always check to make sure there is no refrigerant gas leakage.
- Presence of airflows. Do not expose persons directly to cold or hot airflows.
- Do not block the entrance or exit of airflows.
Presence of non-drinkable water. Do not drink water leaking from the machine.
- To avoid contamination of food, it must not come into direct contact with the machine but must be placed in
appropriate containers.
- Presence of gas pipes with high or low temperature. Before touching the pipes make sure of their temperature. Use
suitable protective gloves.
- Presence of lamps. Before touching the lamps or parts close to them, make sure they are not hot. Use suitable
protective gloves
- Presence of cold environments. If someone enters the machine, always make sure the door remains open.
- The floor and footboard may be slippery. Always keep the floor and footboard clean and dry. Wear shoes with rubber
soles.
- Presence of glass or Plexiglas parts. -Do not strike the glass or Plexiglas parts violently.
- Do not place anything on top of the glass or Plexiglas parts.
- Do not obstruct the movement of the Plexiglas cover when it opens or closes.
- Do not keep, use or bring flammable gas or fuel near the machine.
- In case of abnormal noise, smells or smoke coming from the machine, pull out the plug.
- Do not install the machine where it is directly exposed to wind full of salt from the sea.
not applicable
not applicable
not applicable
4