Unpacking; Positioning; Electrical Connections - Evco EV3B23 Manual De Instrucciones

UNPACKING

Check that the packaging is intergal before removing it, contesting and writing any damage detected on the delivery
note. After having removed the packaging make sure that the appliance is integral; if it is damaged, inform the dealer
immediately via fax or registered letter with receipt of acceptance and if damage is such to jeopardise machine safety
do not install it until a qualified technician has intervened. The packaging (plastic bags, boxes, nails etc.) must not be
left within reach of children and pets as it is a potential danger.

POSITIONING

For correct installation, check that in the area of installation the air inlets are not obstructed, which are necessary for
correct functioning of the machine. The machine must be installed and levelled to guarantee stability; any other
different solution for installation must be agreed and approved by the manufacturer. If the cabinet has wheels, position
it in a flat area and block them before powering the appliance.

ELECTRICAL CONNECTIONS

THE APPLAINCE IS SUPPLIED WITHOUT A PLUG TO CONNECT TO THE POWER SUPPLY LINE.
THE PRODUCER IS RELIEVED FROM ANY RECOURSE IF THE CONNECTIONS ARE PERFORMED BY THE
USER OR UNQUALIFIED STAFF.
- Check integrity of the power supply cable. If it is damaged, have it replaced by qualified staff
- The electric power supply must be compatible with the indications given on the electric diagram.
- A master switch must be available for the connection it must be omnipolar, which interrupts all contacts excluding the
neutral, with distance between open contacts of at least 3 mm, with magnet circuit breaker trip or coupled to fuses, to
be dimensioned or calibrated in compliance with the power indicated on the machine plate.
- The master switch must be on the electric line near to the installation and must only serve one appliance at a time
- An efficient EARTH plant must already be present, to which the machine must be connected
- Adapters, multiple sockets, cables with inadequate section or extension joints that are not in compliance with specific
requests of the standards in force must be excluded
- For details regarding electrical functioning, consult the diagram attached to the manual or positioned on the back of
the machine
- The power supply cable cannot be pulled or crushed during normal functioning or routine maintenance.
7