Additional Safety Rules - Makita 4101RH Manual De Instrucciones

ENGLISH
1 Wing bolt
2 Water pipe
3 Hex wrench 5
4 Loosen
5 Tighten
6 Wrench 22
7 Inner flange
8 Diamond wheel
9 Outer flange
0 Hex socket head bolt
q Base
SPECIFICATIONS
Model
Wheel diameter .......................................... 125 mm
Max. cutting capacities
At 90° ...................................................... 41.5 mm
At 45° ......................................................... 26 mm
No load speed (RPM) ................................... 12,000
Overall length ............................................. 236 mm
Net weight ...................................................... 2.9 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. This machine should be grounded while in
use to protect the operator from electric shock. Use
only three-wire extension cords which have three-
prong grounding-type plugs and three-pole recep-
tacles which accept the machine's plug.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.

ADDITIONAL SAFETY RULES

1. This machine is equipped with a portable
residual current device. Do not connect the
machine to a power supply without using the
PRCD (Portable Residual Current Device). In
case of damage of the cord, it has to be
replaced by the manufacturer's service orga-
nization.
2. For additional protection against electric
shock, be sure to WEAR RUBBER GLOVES
AND RUBBER BOOTS during operation.
3. Check the wheel carefully for cracks or dam-
age before operation. Replace cracked or
damaged wheel immediately.
6
Explanation of general view
w Wing nut
e This end of blade case should
be above the red line.
r Red line
t ''TEST'' button
y ''ON'' button
u Pilot lamp
i Portable
residual
device (PRCD)
o Switch trigger
p Lock-off button
4. Use only flanges specified for this machine.
4101RH
5. Be careful not to damage the spindle, flanges
(especially the installing surface) or bolt. Dam-
age to these parts could result in wheel break-
age.
6. When using the water feed, be careful not to
let water get into the motor. If water runs into
the motor, an electric shock hazard may result.
7. Hold the machine firmly.
8. Keep hands away from rotating parts.
9. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
10. Wait until the wheel attains full speed before
cutting.
11. Stop operation immediately if you notice any-
thing abnormal.
12. Do not attempt to lock the trigger in the ''ON''
position.
13. Never attempt to cut with the machine held
upside down in a vise. This can lead to serious
accidents, because it is extremely dangerous.
(Fig. 1)
14. Before setting the machine down after com-
pleting a cut, be sure that the wheel has come
to a complete stop.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Installing water pipe (Fig. 2)
First, unplug the machine. Loosen the wing bolt on the
depth guide and move the base down. Install the
water pipe on the blade case using the screw as
shown in Fig. 2. Attach the vinyl tube onto the water
pipe and attach the adapter on the vinyl tube to a
faucet of water mains pressure. Adjust the amount of
water flow by simply adjusting the water cock.
a Top guide
s For straight cuts
d For 45° bevel cuts
f Clamp
g Cover (A)
h Screw
j Cover (B)
current
k Limit mark
l Brush holder cap
; Screwdriver