Technical Data - EINHELL EH 3000 Manual De Instrucciones

Anleitung_EH_3000_SPK7:_
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1 Heat output switch
2 Thermostat control
3 Heater
4 Air outlet grille
5 Fan
3. Items supplied
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
Electric heater
4. Intended use
The equipment can be used in enclosed rooms in a
free standing position for room heating. Keep a
minimum distance of 1 m between the front of the
housing and walls, combustible materials (furniture,
curtains, etc.) and 30 cm from all other housing
surface areas. The equipment may only be used
completely mounted and standing vertically on a
stable surface. It is prohibited to operate the
equipment on an instable surface (e.g. on a bed).
03.03.2011 7:34 Uhr Seite 7
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data:

Rated voltage:
Output:
Thermostat control:
Protection type:
Appliance dimensions, approx.:
6. Before starting the equipment
Important! Before using the equipment for the first
time, check that the voltage supply is the same as
the voltage details set out on the rating plate.
Read the safety regulations in section 1.
Check the correct air throughput by holding a
sheet of paper at a distance of 10 cm in front of
the air outlet grille in air circulation mode (without
heating). The paper must be blown away from
the air outlet grille.
When the equipment is used for the first time or
after a long period of rest it may emit an odor for
a short time. This is not a fault.
Because the heating system works with specially
encapsulated heating elements and a high air
delivery rate, the emitted air may be felt to be
cooler than that from a conventional fan heater.
This is not an equipment defect.
7. Using the equipment
7.1 Heat output switches (Fig. 1):
Off setting (0)
Fan setting (
Low heat output
Maximum heat output
GB
230 V ~ 50 Hz
3000 W (1500 W / 3000 W)
Infinitely adjustable
29,5 x 25 x 43 cm
✶ )
IP24
7