Operation; Opening The Impact Flap ( 10); Folding The Handlebar In And Out (11); Adjusting The Handlebar To The Body Size (12) - AL-KO Energy Flex SF 4036 Manual De Instrucciones

Operation

Switching off the power supply
1. Turn the key switch (09/2) to the Off position
(position 0) (09/b).
NOTE
The key of the key switch can be re-
moved in the Off position.
2. Immediately after use, pull the rechargeable
battery out of the appliance, charge and store
in a frost-protected area. Only insert the re-
chargeable battery in the appliance immedi-
ately before the next use.
6 OPERATION
NOTE
Always mow the grass before scarifying
(max. grass height: 4 cm).
Remove any foreign bodies from the
grass surface.
6.1

Opening the impact flap ( 10)

The appliance can be operated with or without
grass collector. The grass collector is available
as an accessory.
Scarifying without grass collector
NOTE
The impact flap is closed on delivery. Al-
ways open the impact flap before scari-
fying so that the scarified material can
be discharged at the impact flap.
1. Fold the impact flap (10/1) back until it audi-
bly engages at an angle of approx. 30°.
Scarifying with grass collector
Fold the impact flap completely up. Using the
grass collector: see chapter 6.6 "Attaching and
removing the grass collector [optional] (15)",
page 46.
442240_a
6.2

Folding the handlebar in and out (11)

CAUTION!
Danger of crushing
Fingers or other parts of
the body can be crushed
between the loose parts of
the handlebar.
■
Hold the loose parts of
the handlebar tightly.
■
Do not hold any fingers
or other parts of the
body between the loose
parts.
Folding in the handlebar
1. Release the quick release (11/1) and fold the
top handlebar (11/2) downwards (11/a).
2. Release the quick release on the rotary/snap-
in joints (11/3) until the entire handlebar
(11/4) can be folded forward into the horizon-
tal position (11/b).
3. Slightly tighten all quick releases.
Folding out the handlebar
Proceed in reverse order.
6.3 Adjusting the handlebar to the body
size (12)
1. Loosen the quick release on the rotary/snap-
in joints (12/1).
2. Adjust the entire handlebar to the desired
height (12/a) at the handle (12/2). The move-
ment is limited by the end stops (12/3) of the
rotary/snap-in joints.
3. Tighten the quick releases (12/1).
6.4 Setting the working depth (13)
The setting of the working depth depends on:
■
Grass condition (well-kept: low working
depth, overgrown: large working depth)
■
Blade wear (new: low working depth, worn:
large working depth)
If the working depth is too large: The appliance
stands still and the motor does not run.
45