Miter Gauge Storage; Transporting Table Saw With Stand; Table Saw Storage - skilsaw SPT99 Instrucciones De Funcionamiento

MITER GAUGE STORAGE

When not in use, the miter gauge can be stored
under the back right side of the table.
1. Insert the front end of the miter guide into the
slot located at the bottom of the push stick
holder (Fig. 19).
2. Snap the base end of the miter guide into the
clip located at the rear of the saw.
FIG. 19
TRANSPORTING THE TABLE SAW
WITH STAND
Keep fingers clear of hinge
points when folding or
un-folding the stand.
Setup. See Fig. 21a.
1. Place the tool in the vertical orientation
2. While holding the handlebar, depress the re-
lease lever with your foot and press down
gently on the handle bar until the stand clicks
into its locked down position.
3. Adjust the stand for levelness as needed.
Storage, Transporting, and Mounting
Miter Gauge
Clip

TABLE SAW STORAGE

When not on the stand, store the tool only in a
level orientation, as shown in Fig. 20a.
When using the stand, the tool may be stored in
either a horizontal or vertical and orientation
(Fig. 20b or Fig. 20c). Storing the tool in any
other orientation may lead to tool damage. To
unfold or store the stand, see "Transport the
Table Saw with Stand."
FIG. 20a
FIG. 20b
Collapsing the Stand, See Fig. 21b
1. Hold the handle bar and depress the release
lever with your foot.
2. Raise the handle until the tool is in its full
upright position and the latch clicks into
place.
Loading/Unloading from the Truck
1. Orient the folded stand with the handle bar
loops facing the truck bed.
2. Place rounded handle loops on the truck bed.
Lift the wheel end of the stand via the stand
left-side support bar and slide into truck
3. Reverse process to unload.
-25-
FIG. 20c