Sawing Grooves; Service And Maintenance - Festool KS 60 E Manual De Instrucciones

English
46-47° inclination to the right/left
(undercutting)
► Loosen the star handle
► Press the release button
relieve the tension by slightly tilting it in the
opposite direction.
► Tilt the saw unit to the limit stop
► Press the release button again
► Tilt the saw unit again
► Tighten the star handle
8.7

Sawing grooves

The continuously adjustable groove depth limit
can be used to individually define groove areas
using the total cutting depth. Grooving or facing
is therefore possible at any height for any work­
piece size.
The round shape of the saw blade
means that, when grooving, a slight
cutting curve upwards is required.
For grooving that is precisely horizon­
tal, a tap block must be clamped be­
tween the workpiece and the stop rul­
er so that a clearance of 4 cm can be
guaranteed.
► Move the machine into the working position.
Only turn down the lever for the
groove depth limit [1-4] if the saw
unit is in the upper position (= work­
ing position).
► Pull the lever for the groove depth lim­
it [1-4] all the way to the front.
The saw unit can now be pushed down only
as far as the preset cutting depth.
► Turn the lever for the groove depth limit to
set the required depth (turn to the left = in­
crease the groove depth, turn to the right =
decrease the groove depth)
Push down the saw unit as a trial run to check
whether the groove depth limit is set to the re­
quired groove depth.
30
.
; if required,
.
.
.
.
Only push the saw unit down when the
lever for the groove depth limit has
engaged in one of the two end posi­
tions. Risk of damage to the power
tool.
► Make the cuts.
► To deactivate the groove depth limit, reset
the lever [1-4].
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festool.co.uk/service
5
3
2
1
Follow the instructions below:
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► Use an extractor on all openings of the pow­
er tool to remove wood chips and splinters.
Sawing chips and small parts that get
caught up in the sawing channel can be
gently pulled out through the open­
ing [12-4].
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
Cleaning the machine regularly, espe­
cially the adjusting devices and guides, is
an important safety factor.
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the