Cleaning
1. Position the cot
cot out to the side (see Fig. B).
2. Fold the outer legs all the way up (see Fig. C).
3. Fold out the legs of the cot so that the bed surface is stretched out
(see Fig. D).
4. Once folded-out, turn the cot over (see Fig. E).
The bed surface is now facing up.
5. Push a lateral brace
and bottom end of the cot. In the process, pay attention to alignment of the
notches in the lateral braces to the bed surface (see Fig. F).
6. Pull the bed surface's cover tight over the lateral braces and anchor the
lateral braces' notches into the ducts on the side of the cot's frame
(see Fig. G).
You will have to use some force to do so. Make sure that each lateral brace
audibly and noticeable locks into place.
You have successfully set up the cot and can begin using it (see Fig. H).
Disassembling the cot
CAUTION!
Risk of injury!
Improper disassembly and use of the cot may result in injury.
− When taking the cot apart, make sure not to squash your
fingers. If possible, wear suitable work gloves.
− Reverse the steps described in the chapter "Setting up the cot" to disassem-
ble the cot.
Cleaning
NOTICE!
Risk of damage!
Improper handling of the cot may damage it.
− Do not use any aggressive cleaners, brushes with metal or nylon
bristles, or sharp or metallic cleaning utensils such as knives,
hard scrapers and the like. They could damage the surfaces.
10
2
'on end' (upright) in front of you and fold the legs of the
through its designated loop in the cover at the top
3