Maintenance & Care - La Crosse Technology WT-5120 Instrucciones De Uso

A. MOUNTING WITH SCREWS
1. Remove the mounting bracket from the remote temperature sensor. The bracket should snap
off easily.
2. Place the mounting bracket over the desired location. Through the three screw holes of the
bracket, mark the mounting surface with a pencil.
3. Where marked, start the screw holes into the mounting surface.
4. Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the
bracket.
5. Snap the remote temperature sensor onto the mounted bracket.
B. MOUNTING WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting
surface to ensure a secure hold. The mounting surface should be smooth and flat.
2. Remove the protective strip from one side of the tape. Adhere the tape to the designated area
on the back of the mounting bracket. Remove the protective strip from the other side of the
tape. Position the remote temperature sensor in the desired location, ensuring that the projec-
tion alarm clock can receive the signal.
GB
P.22
Problem: The LCD is faint.
Solution: Replace the batteries.
Problem: "OFL" appears in the indoor temperature LCD.
Solution:
1. Move unit to an area with warmer or cooler surrounding temperature.
2. Current surrounding temperatures are outside measuring range.
Problem: No reception of WWVB signal.
Solution:
1. It may help reception to face the front of the projection alarm in the general direction of Ft.
Collins, Colorado.
2. Wait overnight for signal.
3. Be sure the projection alarm is at least 6 feet from any electrical devices, i.e. TV sets, computers,
or other radio controlled clocks.
4. Remove batteries for five minutes, reinsert and leave the unit alone overnight without pressing
buttons.
5. If problems persist contact La Crosse Technology.
GB
P.24
VI. MAINTENANCE & CARE
A. Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the
units.
B. Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents-they
may mark and damage the displays and casings.
C. Do not submerge in water.
D. Immediately remove all low powered batteries to avoid leakage and damage.
E. Replace with new batteries only, and of recommended size.
F. Opening the casings invalidates the warranty. Do not try to repair the units. Contact La Crosse
Technology for Repairs.
TROUBLESHOOTING
Problem: The Projection is faint
Solution:
1. Change intensity setting
2. Use AC adapter
3. Darken surroundings
4. Use fresh batteries (if AC is not used)
Problem: Hour is incorrect (minute is correct).
Solution: Be sure correct time zone and daylight saving time are selected.
Problem: "—.-" appears in outdoor temperature LCD
Solution:
1. Check batteries in remote
2. If batteries are replaced in remote, the unit must be re-started. Remove all batteries, and then
follow start up procedure.
Problem: "OFL" appears in the outdoor temperature LCD
Solution:
1. Remote temperature is out of range.
2. Check batteries.
3. Interference from an outside source (cordless telephone, etc.)
4. Contact La Crosse Technology.
Note: For any questions not answered, contact La Crosse Technology with the contact information
found at the end of this instructional manual.
GB
P.23
GB
P.25