Usb Socket For Smartphone Charging; Setup Options - Festool SYSROCK BR 10 DAB+ Manual De Instrucciones


Never use the Aux-In socket in
rainy or moist conditions to pre-
vent moist from entering the
SysRock. Make sure that the
rubber cover on top fits thightly
when operating in a moist envi-
ronment.
5.12 USB socket for smartphone
charging
Your radio has a USB socket which is
intended only for charging a smart-
phone or similar devices. Charge
time may vary and in some cases may
take longer to charge than when us-
ing the manufacturers charging unit
supplied with the smartphone. The
radio can charge the smartphone or
similar devices when the radio is in
power on mode and in DAB/FM radio
mode, Bluetooth mode or AUX mode.

Connect your smartphone to the
USB charging socket [1-4] on the
top of your radio.

Your smartphone will begin to
charge.

Once your smartphone has fully
charged remove the USB cable.

NOTE: Charging mobile phones
(for example) or other devices
may affect the listening quality
while listening to the DAB/FM
stations.
CAUTION
– The charger may not supply pow-
er to some USB devices.
– When not using or after charging,
remove the USB cable.
– Do not connect power source to
USB port. Otherwise there is a
risk of fire. The USB port is only
intended for charging lower volt-
age device.
– Do not insert a nail, wire, etc. into
the USB power supply port. Oth-
erwise a circuit short may cause
smoke and fire.
– Do not connect this USB socket
with your PC USB port, as it is
highly possible that it may cause
breakdown of the units.
– Never use the USB socket in
rainy or moist conditions to pre-
vent moisture from entering the
radio.
– Close the USB socket after use
with the protective cap to prevent
contamination.

5.13 Setup options

Attachment handle [1-1]
The folding attachment handle allows
you to hang the device from scaffold-
ing or similar structures.

If you decide to power the device
with an external Festool battery
pack, the attachment handle
GB
BR 10 DAB+
31