Handle Adjustment - Swisher Trim-Max Manual Del Propietário

Contents of Box:
• Trimmer
Parts bag containing:
• Manual
• Engine manual
• Safety goggles
• Bottle of engine oil
• Trimmer line
• Hex wrench

Handle Adjustment

• Fill engine crankcase with oil. A 20oz. bottle has been provided with this unit. A new unit
requires 18-20oz. DO NOT OVERFILL.
• Fill the engine fuel tank with gasoline. GASOLINE SHOULD BE ADDED OUTSIDE IN A
WELL-VENTILATED AREA.
• Check to ensure string has been installed properly. A diagram is provided just above the trimmer
head for proper installation.
• Refer to engine manufacture's manual for oil and fuel specifications.
Important!
Use the proper length of line. Using a line too long for the unit will cause
stalling and unacceptable operation.
Use 18" Trimmer Line Part Number P3618
•
Loosely fold trimmer line in half.
•
Insert line through the bottom holes of the cutting disc (Step 1).
•
Bring ends around and through the slot in the cutting disc flange (Step 2).
•
Pull ends to tighten loop (Step 3).
Assembly
Tools Required:
•
Installation of handles:
1.
2.
3.
4.
5.
Handles may be adjusted up and down and in and out for
comfortable operation.
Preparing Unit For First Use
Installing Trimmer Line
½" Wrench
Remove loose fasteners from trimmer frame handle
holes.
Pivot handles up and align holes in handle with holes
on trimmer frame. Install hardware removed in
previous step. Snug, but do not tighten bolts.
Pivot upper handles to fit the lower handles. Tighten
knobs.
Adjust handles for comfortable operation.
Tighten all bolts.
Step 1 Step 2
6
Step 3