Swisher Trim-Max Manual Del Propietário página 7

Trimmer line attachment positions:
•
Trimmer is equipped with 4 trimmer line attachment points.
•
When mowing with trimmer, the 4 trimmer line configuration is recommended for a more consistent,
even cut.
•
When trimming tall or thick vegetation, the 2 trimmer line configuration is recommended for improved
performance.
To adjust cutting height:
1. Loosen set screw using hex wrench provided.
2. Slide cutting head up or down to desired cutting height.
3. Tighten set screw.
4. Any cutting height may be used with either trimmer line configuration.
4 Trimmer line Configuration
Shown set at Low cutting height
Important!
To ensure proper operation, clean the engine and trimmer regularly. Remove any build up
of chaff from the top of the engine. During operation debris may get wrapped around trimmer head.
Prolonged use in this condition may result in excessive wear and part failures. Periodically turn off trimmer
and remove debris.
To start the trimmer:
1. Remove any built up debris from engine and trimmer head.
2. Read and follow starting instructions listed in your engine manual.
3. When engine starts, leave throttle control at "FAST". Throttle control must be set in the fast position
for maximum performance.
4. Engage trimming head.
5. Begin trimming.
To engage/disengage trimmer head:
• Engage: Bring control bail into contact with the upper handle and grip it together with the handle. If
trimmer head does not fully engage, see belt adjustment section.
• Disengage: Release control bail. Trimmer head should stop within a few seconds. If it does not, see
belt adjustment section.
To stop the trimmer:
1. Release the control bail.
2. Move throttle control lever on engine to "SLOW" for a few seconds then move to "STOP".
Important!
For safest operation, make sure debris is directed away from you and others.
Trimmer Line Positions
Operation
7
Set Screw
2 Trimmer line Configuration
Shown set at High cutting height