Alto Uber Guia Del Usuario página 7

Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Uber using the Master
Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume
from your source.
If you can't hear your instrument: Check the setting of the Line/Mic switch. If you are using
an instrument with passive pickups, set the switch to the Mic setting.
If you can't play music from a flash drive: The USB port is only for charging USB devices.
RF Exposure Information
Maximum RF Power: Bluetooth (2402–2480 MHz): 5.32 dBm
The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20
cm between the device and the human body. To maintain compliance with RF exposure
requirement, use product that maintain a 20 cm distance between the device and human body.
Regulatory Conformance
Hereby, inMusic Brands, Inc. declares that the radio equipment type (ÜBER battery-
powered performance PA) is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following Internet address:
altoprofessional.com/safety
Notice: Observe the national local regulations in the location where the device is to be used. This
device may be restricted for use in some or all member states of the European Union (EU).
7