Operation - Delta 46-715 Manual De Instrucciones

ADJUSTING CLAMP ON TOOL REST
To adjust the tool rest clamping action, use a 15/16" wrench to adjust the nut (A) Fig. 16 in the same manner as the headstock and
tailstock.
A
C
ATTACHING ON/OFF SWITCH TO TOOL
The "ON/OFF" switch comes unattached to the tool to protect it from damage in shipping. To attach the "ON/OFF" Switch:
1. Remove the two hex bolts (A) Fig. 19 that are attached to the back of the headstock, located near the top.
2. Align the two holes in the bottom of the "ON/OFF" switch with the two holes where the hex bolts were removed in STEP 1.
3. Secure the "ON/OFF" switch to the headstock with the bolts that were removed in STEP 1 (Fig. 20).
C
OPERATIONAL CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING THE TOOL
Make sure that the switch is in the "OFF" position before plugging cord into outlet. Do not touch the plug's metal
prongs when unplugging or plugging in the cord.
The power switch (A) Fig. 22, located under the safety cover (B) Fig. 21, provides electrical power to the adjustable speed drive. Lift
the safety cover (B) and move the switch up to the "ON" position. To turn the power off, push the safety cover (B) down. NOTE: In
case of emergency, immediately push the safety cover (B) down to shut off power.
LOCKING SWITCH IN THE "OFF" POSITION
IMPORTANT: When the tool is not in use, the switch should be locked in the "OFF" position to prevent unauthorized use, using a
padlock (C) Fig. 22, with a 3/16" diameter shackle inserted through the holes in the switch plate (D) Fig. 22B.
In the event of a power outage (such as a breaker or fuse trip), always move the switch to the "OFF" position
until the main power is restored.
B
Fig. 21
Fig. 17
D
Fig. 19

OPERATION

B
C
9
A
D
Fig. 22
Fig. 18
Fig. 20
Fig. 22B