DeWalt DCH253 Manual De Instrucciones página 14

FIG. 5
C
UNLOCKED,
FORWARD
Worklight (Fig. 6)
CAUTION: Do not stare into worklight. Serious eye injury could
result.
There is a worklight (F) located on the front
of the tool. The worklight is activated
when the trigger switch is depressed, and
will automatically turn off 20 seconds after
the trigger switch is released. If the trigger
switch remains depressed, the worklight
will remain on.
NOTE: The worklight is for lighting the
immediate work surface and is not intended to be used as a flashlight.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
WARNING: To reduce the risk of personal injury, ALWAYS
ensure workpiece is anchored or clamped firmly. If drilling thin
material, use a wood "back-up" block to prevent damage to
the material.
LOCKED UNLOCKED,
REVERSE
FIG. 6
F
WARNING: To reduce the risk of personal injury, ALWAYS
operate the tool with the side handle properly installed and
securely tightened. Failure to do so may result in the side handle
slipping during tool operation and subsequent loss of control. Hold
tool with both hands to maximize control.
Installing and Removing the Battery Pack
(Fig. 7)
WARNING: To reduce the risk of injury, never depress the battery
release button without removing the battery pack. Depressing the
battery release button without removing the battery pack can result
in the battery pack falling out unexpectedly.
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (G) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it does
not disengage.
FIG. 7
G
To remove the battery pack from the tool, press the release button (H)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
12
H