Initial Operation; Device Placement - HellermannTyton TT4000+ Manual De Instrucciones

"IRRECOVERABLE ERROR" state
An error has occurred that cannot be rectified by the user
without cancelling the print job.
The display shows the symbol Error, the type of error and
the number of label still to be printed.
Button Label
cancel Flashes
Cancel the current print job and delete all
enter Lights up Brief information for correcting the fault
"SYSTEM ERROR" state
If an error occurs while starting the system, the system
error symbol and type of error are displayed.
f Switch the printer off using the power switch and then
switch it back on again.
f Press the cancel button.
f If the error occurs again, contact the Service
Department.
Function
Short press
Cancel the current print job
Longer press
print jobs
Call up Help
will be displayed
Operating Instructions • Thermal transfer printer TT4000

5 Initial operation

The following equipment is required for the start-up of
the device:
• PC or notebook with Windows XP®/Vista®/7®/8®
Carry out the start-up in the prescribed sequence:
1. Place the device.
2. Install the drivers.
3. Connect the device.
4. Install the device in the operating system.
5. Install the TagPrint Pro software.
Æ Section 5.1-5.5

5 .1 Device placement

NOTE
Material damage caused by false environmental
conditions!
The device and the materials can be damaged by humidity
and dust.
f Setup the device only in dry places that are not exposed
to spray water or dust.
Proceed as follows:
1 Lift the device carefully out of the packaging using the
holding straps.
2 Place the device on a level and stable surface.
Remove the transport securing devices.
3 Open the device cover.
4 Remove foam transportation safeguards from the area of
the printhead.
5 Check the device for transport damage.
6 Check the delivery for completeness:
• Label printer
• Power cable
• USB cable
• Documentation
• CD-ROM with installation programme and operating
instructions
+ • 01-2016 • 031-93352
Initial operation
1
2
9