Miele APCL WOD Instrucciones De Montaje página 8

8 von 18
A
Level the plinth on the floor.
The flooring must be level and dry with no traces of dirt or grease.
A
Unscrew the front panel.
A
Fill all 4 media canisters with water and seal them tight. Leave the drain valve closed at all times.
A
Place 2 media canisters into the plinth and line them up with the rear of the plinth.
A
Place the other two media canisters into the plinth.
Take great care when placing the media canisters into the plinth. Leave the drain valves closed at all times.
Check that the fill level in the system is constant at regular intervals.
Fitting a washing machine to the plinth
A
Fit the clamps to the front of the plinth and fasten them in the appropriate holes, see Fig. 2.
A
Secure each clamp to the plinth with 1 M6 x 30 bolt (1), 2 galvanised B6.4 washers (2) and 1 M6 nut (3). Do not
tighten the nuts yet, see Fig. 3.
A
Unscrew the washing machine feet by at least 5 mm.
A
Set the washing machine down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the washing machine on the plinth.
A
Use the clamps to fix the washing machine to the front feet, see Fig. 3.
A
Fit another M6 nut (4) to each of the feet to counter the first nut, see Fig. 3.
A
Screw 1 M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 4.
A
Screw the front panel of the plinth back into place.
Fitting a tumble dryer to the plinth
A
Unscrew the tumble dryer feet by at least 5 mm.
A
Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the tumble dryer on the plinth.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 5.
A
Screw the front panel of the plinth back into place.
en
es
Instrucciones de montaje zócalo APCL WOD
Motivo: Con el zócalo se puede obtener una altura de trabajo más ergonómica para la lavadora o la secadora.
Piezas del suministro
Número Nº de mat. Denominación
1 Zócalo
4 Bombona de 20 l
2 Pestaña tensora
4 Arandela galvanizada B6,4
2 Tornillo hexagonal M6 x 30
4 Tuerca hexagonal M6
2 Placa tensora
22.10.2019 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 11477230