OBJ_BUCH-0000000284-001.book Page 22 Tuesday, November 21, 2017 12:14 PM
en
22
Securing the workpiece (figure 12).
Secure the workpiece sufficiently. An
inadequately secured workpiece can, for
example, cause the grinding accessory to
jam. This can lead to kickback, cause the
workpiece to fall down, and lead to
other dangerous situations.
Dry grinding (figure 13).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 14).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.
Fig. 12
Fig. 13
Fig. 14