Step 2 - Door Reversing - Haier HEBF100BXS Manual Del Usuario

INSTALLATION REQUIREMENTS

STEP 2 - DOOR REVERSING

WARNING
to follow these instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and property damage.
The door hinges are factory installed on the right-hand side. If you want the
doors to open from the opposite direction, you can reverse the door swing.
TOOLS NEEDED
• 5/16" Hex-head Wrench
• 3 mm Hex Key
• Putty Knife
IMPORTANT:
• Before you begin, unplug the beverage center, or disconnect power.
• The door is heavy and fragile and the door front is glass. To avoid door
glass breakage, use both hands and grasp only the sides of the door to
remove.
1. Remove all items from inside the beverage center.
2. Using two or more people, gently lay the beverage center on its back.
Keep the machine standing over 4 hours before using if you lay the
beverage center on its back.
3. Using a 5/16" hex-head wrench, remove the three hexagonal screws
fastening the bottom hinge to the cabinet, and set aside.
4. Remove the bottom hinge and the two washers. Set the washers aside.
10
(Optional)
Follow all steps when reversing the door swing. Failure
Bottom
Hinge
Screws
49-60809 Rev. 2