Peg-Perego Prima pPappa Diner Instrucciones De Uso página 8

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR
FUTURE REFERENCE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD PUT
THE CHILD'S SAFETY AT RISK.
_ ALL ASSEMBLY AND OPERATING PROCEDURES SHOULD BE PERFORMED BY AN
ADULT; DO NOT USE THE PRODUCT IF IT HAS BROKEN OR MISSING PARTS.
_ CLEANING AND MAINTENANCE MUST ONLY BE CARRIED OUT BY AN ADULT.
_ PREVENT SERIOUS INJURY OR DEATH FROM FALLS OR SLIDING OUT; ALWAYS USE
COMPLETE 5 POINT SEATBELT; THE CHILD SHOULD BE SECURED IN THE HIGH
CHAIR AT ALL TIMES, EITHER IN THE RECLINED OR IN THE UPRIGHT POSITION.
_ ALWAYS USE THE CROTCH STRAP.
_ NEVER LEAVE THE CHILD UNATTENDED; ALWAYS KEEP CHILD IN VIEW WHILE IN
THE HIGHCHAIR.
_ TRAY AND ACCESSORY TRAYS ARE NOT DESIGNED TO SUPPORT THE CHILD'S
WEIGHT; TRAY IS NOT DESIGNED TO HOLD THE CHILD IN THE CHAIR.
_ ALWAYS USE THE HIGHCHAIR ON A FLAT, HORIZONTAL SURFACE.
_ IT IS RECOMMENDED THAT THE HIGH CHAIR BE USED IN THE UPRIGHT POSITION
ONLY BY CHILDREN CAPABLE OF SITTING UPRIGHT.
_ BE CAREFUL OF WHERE YOU PLACE THE PRODUCT. AVOID PLACING THE CHILD
NEAR SAFETY HAZARDS SUCH AS ELECTRICAL CORDS, SOURCES OF HEAT, OR
FLAMES.
_ DO NOT PUT FINGERS IN THE MECHANISM. MAKE SURE YOUR CHILD'S ARMS AND
LEGS ARE CLEAR OF THE MOVING PARTS DURING ADJUSTMENT.
_ USING ACCESSORIES THAT HAVE NOT BEEN APPROVED BY THE MANUFACTURER
MAY BE HAZARDOUS.
_ DO NOT USE THE PRODUCT NEAR STAIRS OR STEPS.
_ BE CAREFUL NOT TO PLACE THE PRODUCT NEAR SOURCES OF HEAT OR FLAMES,
SUCH AS GAS STOVES, ELECTRIC HEATERS, ETC.
_ MAKE SURE THE BELT IS ATTACHED PROPERLY.
_ DO NOT USE THE HIGH CHAIR UNLESS ALL OF THE PARTS ARE PROPERLY FITTED
AND ADJUSTED.
_ NOTICE: THIS ARTICLE MEETS OR EXCEEDS ALL REQUIREMENTS COVERED IN
ASTM F833 STANDARD AND LATEST REVISIONS.
INSTRUCTIONS
1 FITTING THE FRONT AND REAR WHEELS: fit the two front wheels to the front of the high chair (fig_a) and the
rear ones, with the brake, to the rear (fig_b), by pushing in the direction of the arrow.
2 OPENING: when it is removed from the packaging, the high chair is not in the correct position for use (packing
position). For use, raise it up until it engages with a click at one of the seven chair heights (fig_a). To open the
high chair, push the red side levers down (fig_b) and push the back supports outwards.
3 Before using the high chair, remove the spacers (fig_a) and lower the footrest (fig_b).
4 BRAKE: the rear wheels of the high chair are fitted with brakes. To apply the brakes, lower the levers on the
rear wheels. To release them, raise the levers. It is recommended that you apply the brakes before carrying out
any procedures involving the high chair.
5 TRAY: to fit the tray, pull the lever underneath it towards you (fig_a) while at the same time inserting it onto
the armrests, and push down fully (fig_b). The tray is extendible to three positions (fig_c). The third position
(indicated with red markings) should not be used and is only for reclosing the tray.