Ottobock 28P30 Instrucciones De Uso página 21

2) Fasten the straps.
3) Make sure that the straps fit closely without constriction.
Application of the 28P30 Manu Neurexa plus with 5065N Omo Neurexa plus
Prerequisite: The covers of the snap fasteners on the 28P30 Manu Neurexa plus have been
>
removed.
Prerequisite: The 28P30 Manu Neurexa plus has been put on.
>
Prerequisite: The 5065N Omo Neurexa plus has been put on.
>
Prerequisite: The suitable connecting straps have been attached to the snap fasteners of the
>
shoulder cuff.
Prerequisite: The forearm cuff of the 5065N Omo Neurexa plus has been removed.
>
1) Open the hook-and-loop closures of the connecting straps.
2) Attach the strap guide loops to the snap fasteners on the wrist orthosis (see fig. 39, see
fig. 40), connecting the snap fasteners of the same colour to each other (black-black/red-red).
3) Guide the connecting straps through the strap guide loops from the inside to the outside and
adjust the length with the hook-and-loop closure (see fig. 41, see fig. 42). The strain on the
shoulder joint should be relieved and the shoulder should be rotated slightly outwards.
4) Check the relief function on the shoulder. Adjust the length of the straps if necessary.
5.4 Retrofitting
Changing the hand support of the 28P31 hand positioning splint to the hand support bar
of the 28P30 Manu Neurexa plus
1) Open all straps (see fig. 30, see fig. 31).
2) Open the safety closure (see fig. 32).
3) Remove the hand support from the hand support bar (see fig. 33, see fig. 34).
4) Attach the hand support pad to the hand support bar with the fixation strap (see fig. 35, see
fig. 36) and fasten the strap (see fig. 37).
5.5 Removal
1) Open all straps.
2) Remove the orthosis from the forearm.
6 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
Textile pads
1) Remove all textile pads from the orthosis.
2) Fasten all hook-and-loop closures.
3) Recommendation: Use a laundry bag or net.
4) Wash the textile pads in warm water at 30 °C with standard mild detergent. Do not use fabric
softener. Rinse thoroughly.
5) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
6) Reattach the textile pads to the orthosis.
Orthosis frame
1) Wipe with a damp cloth as needed.
2) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
21