Operating Suggestions; After Use; Routine Maintenance; General Information - Alpina ABL 40 Li Manual De Instrucciones

Soplador portátil de jardín a batería
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 132
– low blowing speed
control in position 1-2)
materials and small shrubs on
– medium blowing speed (speed adjustment
control in position
grass and leaves on asphalt or firm ground;
– high blowing speed (speed adjustment
control in position 4-5) for wet
leaves and heavier materials, such
as fresh snow or bulky waste.

6.4.2 Operating suggestions

Proceed slowly keeping the end of
the blower tube at a suitable distance
from the ground (Fig. 5).
To avoid dispersing the material to be
removed, direct the air flow towards the
outer edges of the pile of material. Never
direct the air flow to the middle of the pile.
6.5 STOP
To stop the machine, release the
throttle control (Fig. 4A).
It takes a few seconds for the rotor to
stop after the machine has been turned off.
Always stop the machine when moving
between different work areas.
While moving the machine, never
keep the
hand on the throttle control to
avoid starting the machine

6.6 AFTER USE

• Remove the battery from its housing
and recharge it (para. 7.2.2).
• Allow the engine to cool before
storing in an enclosed space.
• Clean (para. 7.3).
• Check there are no loose or damaged
components. If necessary, replace
the damaged components and tighten
any screws and loose bolts or contact
the authorised service centre.
IMPORTANT Always remove the
battery (para. 7.2.2) whenever the
machine is unused or left unattended.
(speed adjustment
for lightweight
lawns;
3)
to move lightweight
accidentally.

7. ROUTINE MAINTENANCE

7.1

GENERAL INFORMATION

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
Before performing any
maintenance operations:
• Stop the machine;
• Remove the battery from its housing
and recharge it (para. 7.2.2);
• Allow the engine to cool before
storing in an enclosed space.
• Wear suitable clothing, protective
gloves and goggles;
• Read the relevant instructions.
– The frequency and types of maintenance
are summarised in the "Maintenance
Table" (see chapter 12). The table will
help you maintain your machine's safety
and performance. It summarises the
main interventions to be made and the
frequency applicable to each of them.
Carry out the relevant task as soon
as it is scheduled to be performed.
– The use of non-original parts and
accessories could have negative effects
on machine operation and safety. The
manufacturer declines any responsibility for
damage or injury caused by said products.
– Genuine spare parts are supplied
by Authorised Assistance
Centres and Dealers.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.
7.2 BATTERY
7.2.1 Battery power reserve
Battery power reserve (and therefore
the cuttable area before recharging is
required) mainly depends on how the
operator works. who should avoid::
– switching the machine on and off
frequently whilst working;
– a rotor speed not suited to the type of
material to be removed (paragraph 6.4.1).
EN - 10

Publicidad

Tabla de contenido
loading

Tabla de contenido